SDIO_ITConfig

ファームウェア関数一覧

SDIO_ITConfig †

ヘッダ宣言 †

関数プロトタイプ †

void SDIO_ITConfig(uint32_t SDIO_IT, FunctionalState NewState)

動作 †

• SDIO周辺回路の割り込みの設定をします。

引数 †

• SDIO_IT
  

  SDIO_IT	説明
  SDIO_IT_CCRCFAIL	Command response received (CRC check failed) interrupt mask
  SDIO_IT_DCRCFAIL	Data block sent/received (CRC check failed) interrupt mask
  SDIO_IT_CTIMEOUT	Command response timeout interrupt mask
  SDIO_IT_DTIMEOUT	Data timeout interrupt mask
  SDIO_IT_TXUNDERR	Transmit FIFO underrun error interrupt mask
  SDIO_IT_RXOVERR	Received FIFO overrun error interrupt mask
  SDIO_IT_CMDREND	Command response received (CRC check passed) interrupt mask
  SDIO_IT_CMDSENT	Command sent (no response required) interrupt mask
  SDIO_IT_DATAEND	Data end (data counter SDIDCOUNT is zero) interrupt mask
  SDIO_IT_STBITERR	Start bit not detected on all data signals in wide bus mode interrupt mask
  SDIO_IT_DBCKEND	Data block sent/received (CRC check passed) interrupt mask
  SDIO_IT_CMDACT	Command transfer in progress interrupt mask
  SDIO_IT_TXACT	Data transmit in progress interrupt mask
  SDIO_IT_RXACT	Data receive in progress interrupt mask
  SDIO_IT_TXFIFOBW	Transmit FIFO burst writable interrupt mask
  SDIO_IT_RXFIFOBR	Receive FIFO burst readable interrupt mask.
  SDIO_IT_TXFIFOF	Transmit FIFO full interrupt mask
  SDIO_IT_RXFIFOF	Receive FIFO full interrupt mask.
  SDIO_IT_TXFIFOE	Transmit FIFO empty interrupt mask
  SDIO_IT_RXFIFOE	Receive FIFO empty interrupt mask
  SDIO_IT_TXDAVL	Data available in transmit FIFO interrupt mask
  SDIO_IT_RXDAVL	Data available in receive FIFO interrupt mask
  SDIO_IT_SDIOIT	SDIO interrupt received interrupt mask
  SDIO_IT_CEATAEND	CE-ATA command completion signal received for CMD61

• NewState
  

  
  

  NewState	説明
  ENABLE	有効にします
  DISABLE	無効にします

  
  

戻り値 †

• 無し

出力値 †

• 無し

呼び出し関数 †

• 無し

サンプル †

/* Enable Receive FIFO full interrupt */
SDIO_ITConfig(SDIO_IT_RXFIFOF, ENABLE);

参照 †